Glossmen Nm 115 Top Jun 2026

| Step | Action | Key Tips | |------|--------|----------| | | Clean, de‑oil, and sand to 80‑120 grit; remove all contaminants. | Use IPA or a dedicated prep solvent; verify surface cleanliness with a “wet‑squeeze” test. | | 2. Primer | Apply Glossmen NM‑115 Primer (or any compatible aliphatic PU primer) to achieve ≥ 70 % adhesion. | Allow primer to flash (5‑10 min) before top coat. | | 3. Mixing | Combine Part A (base) and Part B (hardener) at 2 : 1 by weight (or as specified). Mix for 2 min with a low‑speed mechanical stirrer. | Avoid entraining air; let the mixture sit 30 s to let bubbles rise. | | 4. Filtration | Pass mixed material through a 100 µm (or finer) filter. | Prevents nozzle clogging, especially when using nanofilled product. | | 5. Spray | Apply 1st thin coat (≈ 20 µm DFT) using 1.2–1.4 mm nozzle, 20 psi at the gun, 30 psi at the fan. Overlap 50 % (wet edge). | Keep spray gun 15‑20 cm from surface; maintain a consistent speed. | | 6. Flash & Recoat | Flash 5‑10 min (depending on ambient). Apply 2nd coat using same parameters. | For high‑gloss finish, a 3rd “wet‑to‑wet” coat may be added. | | 7. Curing | Allow to fully cure 24 h at 20 °C before handling; 48 h for full chemical resistance. | Use a temperature‑controlled curing chamber for faster turnover in production lines. | | 8. Final inspection | Check for orange peel, fish‑eyes, and gloss uniformity (target ΔE*ab < 2). | Polish with a fine‑grit (1500‑2000) polishing pad if required for showroom finish. |

Because the original is nearly impossible to find, the grooming community is constantly searching for a "dupe" or spiritual successor. If you are looking for a product that mimics the , consider these modern alternatives: glossmen nm 115 top

Glossmen stepped out into the cool night air. A small crowd had gathered, phones out, recording the unassuming box that had just humiliated a track-prepped racer. | Step | Action | Key Tips |