Hw 130 Motor Control Shield For Arduino Datasheet __hot__ Site

int ENA = 3; // PWM capable int ENB = 11; // PWM capable

| L293D Pin | Arduino Pin | Function | |-----------|-------------|----------| | Enable 1,2 | D10 (PWM) | Speed control M1/M2 | | Enable 3,4 | D5 (PWM) | Speed control M3/M4 | | Input 1 | D8 | Direction M1 | | Input 2 | D9 | Direction M2 | | Input 3 | D6 | Direction M3 | | Input 4 | D7 | Direction M4 | hw 130 motor control shield for arduino datasheet

0.6A per bridge (1.2A peak) with thermal protection. Voltage: Wide range from 4.5V to 25V DC. int ENA = 3; // PWM capable int

// Test Motor 2 Backward Serial.println("Motor 2 Backward"); digitalWrite(M2, LOW); // Set direction (Opposite logic) analogWrite(E2, 200); // Set speed delay(2000); HW-130 Motor Control Shield (often marketed as the

Based on official datasheets for the L293D chipset and the HW-130 module , the technical limits are as follows: 4.5V to 25V (typical) or up to 36V .

HW-130 Motor Control Shield (often marketed as the L293D Motor Driver Shield) is a versatile, entry-level expansion board for Arduino designed to simplify the complex task of driving inductive loads like DC motors, steppers, and servos. Based on the classic Adafruit Motor Shield V1 design, it centralizes motor control by consolidating multiple H-bridges and shift registers into a single "plug-and-play" footprint. ResearchGate Core Technical Architecture