Danfoss Error 1027 ✦ Verified & Top-Rated

Wait until the LCP (Local Control Panel) display turns off completely. Reconnect the power and see if the error clears. Disconnect mains power and wait for the display to go dark.

Because Error 1027 is frequently flagged as a in Danfoss technical documentation, you may eventually need to replace a component. If the steps above don't work, your best bet is to contact Danfoss Technical Support or your local supplier to discuss a control card replacement. danfoss error 1027

The reaction of the VLT drive to Error 1027 is determined by Users can configure the drive to react in several ways upon losing communication: Wait until the LCP (Local Control Panel) display

It often points to a physical fault on the power card or the control card interface. Immediate Troubleshooting Steps Because Error 1027 is frequently flagged as a

Ensure all power is disconnected and the unit is safe to open.

For qualified technicians only – high energy stored in capacitors.

No. It is a protective response. However, repeated stopping/starting of the load (pump, fan, conveyor) can cause mechanical wear.