Uses 15mm copper or stainless steel pipe. Do not use jointing compound ; use PTFE tape if needed. 📋 Installation Sequence
| Problem | Possible Cause | Solution | | :--- | :--- | :--- | | | No power supply. | Check isolator switch and main fuse. | | | Thermal cut-out activated. | Reset the thermal cut-out button (located behind the cover). | | Water not hot enough | Temperature dial set too low. | Increase temperature setting. | | | Incoming water very cold. | Increase flow rate or temperature setting. | | Water too hot / Steam | Water flow rate too low. | Increase water flow at the tap. | | | Blockage in inlet filter. | Isolate water, remove and clean filter. | | Leakage | Loose connections. | Tighten fittings and check washers. | galaxy aqua premier installation manual
: Do not install where it may freeze or inside steam rooms/cubicles. Uses 15mm copper or stainless steel pipe
In this extensive guide, we will walk through everything you need to know about the installation manual: where to find it, how to interpret the diagrams, a detailed step-by-step installation process, common pitfalls, and advanced troubleshooting tips. By the end, you’ll be able to set up your system with confidence. | Check isolator switch and main fuse