You do not need the original manual if you follow these diagnostic steps on a NetApp system using the NAJ-1501.
| Symptom | Likely Cause | Manual Reference | |---------|--------------|------------------| | No console output | Wrong baud rate (should be 115200) | Appendix A: Serial Settings | | Yellow status LED | Fault detected – run system health show | Chapter 3: LED Interpretation | | SAS shelf not seen | Cable fault or wrong port mapping | Chapter 5: SAS Connections | | Power cycling loop | Corrupt boot device – boot from USB recovery | Chapter 7: Boot Media Recovery | Netapp Naj-1501 Manual
However, I can help you in the following ways: You do not need the original manual if